Elegoo Centauri Carbon vs Elegoo Centauri Carbon 2
The Elegoo Centauri Carbon (2025, €349) and the Elegoo Centauri Carbon 2 (2026, €349) are two FDM 3D printers many people compare before buying.
On the technical side, only the Elegoo Centauri Carbon 2 supports multicolor (AMS).
Below is the full spec table with the best value of each feature highlighted, plus a verdict by use case.
← Swipe to see more →
| Elegoo Centauri Carbon €349 | Elegoo Centauri Carbon 2 €349 | |
|---|---|---|
| Geometry | ||
| Build volume | 256³ mm | 256³ mm |
| Weight | 16 kg | 17.65 kg |
| Speed | ||
| Max speed | 500 mm/s | 500 mm/s |
| Max acceleration | 20,000 mm/s² | 20,000 mm/s² |
| Hot-end | ||
| Max nozzle temp | 320 °C | 350 °C 🏆 |
| Nozzle material | hardened steel | hardened steel |
| Drive type | direct | direct |
| Flow rate | 32 mm³/s 🏆 | — |
| Bed | ||
| Max bed temp | 110 °C | 110 °C |
| Bed material | PEI plate | dual-sided PEI (textured PEI + smooth PLA-specific coating) |
| Auto-leveling | auto mesh + strain gauge | full auto (121-point) |
| Enclosed | Yes | Yes |
| Heated chamber | No | No |
| Multimaterial | ||
| AMS compatible | No | Yes 🏆 |
| AMS type | — | CFS |
| AMS slots | — | — |
| Connectivity | ||
| WiFi | Yes | Yes |
| Ethernet | Yes | — |
| Camera | Yes (720p) | Yes () |
| Calibration | ||
| Vibration compensation | Yes | — |
| Flow calibration | Yes | — |
| Input shaping | Yes | — |
| Pressure advance | Yes | — |
| Software | ||
| Official slicer | Elegoo Slicer (OrcaSlicer fork) | ElegooSlicer |
| OrcaSlicer | Yes | — |
| Noise | ||
| Noise | — | 45 dB 🏆 |
| Power | 400 W 🏆 | 1100 W |
Frequently asked
- Which has better value: Elegoo Centauri Carbon or Elegoo Centauri Carbon 2?
- See the full spec table for the best decision based on your use case.
- Which has the larger build volume?
- Elegoo Centauri Carbon 2 with 256³ mm.