Elegoo Jupiter SE vs Anycubic Photon Mono M7 Pro
The Elegoo Jupiter SE (2023, €629) and the Anycubic Photon Mono M7 Pro (2024, €799) are two MSLA 3D printers many people compare before buying.
The Elegoo Jupiter SE is the more affordable of the two, with a gap of about 170 (~21%) versus the other.
On the technical side, only the Anycubic Photon Mono M7 Pro is enclosed (better for ABS and technical materials), and the Elegoo Jupiter SE offers more build volume (278×156×300 mm).
Below is the full spec table with the best value of each feature highlighted, plus a verdict by use case.
← Swipe to see more →
| Elegoo Jupiter SE €629 | Anycubic Photon Mono M7 Pro €799 | |
|---|---|---|
| Geometry | ||
| Build volume | 278×156×300 mm 🏆 | 223×126×230 mm |
| Weight | 19.5 kg | 11 kg |
| Speed | ||
| Max speed | — | — |
| Max acceleration | — | — |
| Hot-end | ||
| Max nozzle temp | — | — |
| Nozzle material | — | — |
| Drive type | — | — |
| Flow rate | — | — |
| Bed | ||
| Max bed temp | — | — |
| Bed material | — | — |
| Auto-leveling | 4-point manual | automatic |
| Enclosed | No | Yes 🏆 |
| Heated chamber | No | Yes 🏆 |
| Multimaterial | ||
| AMS compatible | No | No |
| AMS type | — | — |
| AMS slots | — | — |
| Connectivity | ||
| WiFi | No | Yes |
| Ethernet | — | No |
| Camera | Yes () | Yes (1080p) |
| Calibration | ||
| Vibration compensation | — | No |
| Flow calibration | — | No |
| Input shaping | — | No |
| Pressure advance | — | No |
| Software | ||
| Official slicer | Chitubox | Photon Workshop |
| OrcaSlicer | — | No |
| Noise | ||
| Noise | — | — |
| Power | 180 W | 120 W 🏆 |
Verdict
- On price, Elegoo Jupiter SE is cheaper.
Frequently asked
- Which has better value: Elegoo Jupiter SE or Anycubic Photon Mono M7 Pro?
- See the full spec table for the best decision based on your use case.
- Which has the larger build volume?
- Elegoo Jupiter SE with 278×156×300 mm.