Anycubic Photon Mono M7 Pro vs Anycubic Photon Mono M7 Max
The Anycubic Photon Mono M7 Pro (2024, €799) and the Anycubic Photon Mono M7 Max (2024, €899) are two MSLA 3D printers many people compare before buying.
The Anycubic Photon Mono M7 Pro is the more affordable of the two, with a gap of about 100 (~11%) versus the other.
On the technical side, the Anycubic Photon Mono M7 Max offers more build volume (298×164×300 mm).
Below is the full spec table with the best value of each feature highlighted, plus a verdict by use case.
← Swipe to see more →
| Anycubic Photon Mono M7 Pro €799 | Anycubic Photon Mono M7 Max €899 | |
|---|---|---|
| Geometry | ||
| Build volume | 223×126×230 mm | 298×164×300 mm 🏆 |
| Weight | 11 kg | 24 kg |
| Speed | ||
| Max speed | — | — |
| Max acceleration | — | — |
| Hot-end | ||
| Max nozzle temp | — | — |
| Nozzle material | — | — |
| Drive type | — | — |
| Flow rate | — | — |
| Bed | ||
| Max bed temp | — | — |
| Bed material | — | — |
| Auto-leveling | automatic | Manual 4-point |
| Enclosed | Yes | Yes |
| Heated chamber | Yes 🏆 | No |
| Multimaterial | ||
| AMS compatible | No | No |
| AMS type | — | — |
| AMS slots | — | — |
| Connectivity | ||
| WiFi | Yes | Yes |
| Ethernet | No | — |
| Camera | Yes (1080p) | Yes () |
| Calibration | ||
| Vibration compensation | No | — |
| Flow calibration | No | — |
| Input shaping | No | — |
| Pressure advance | No | — |
| Software | ||
| Official slicer | Photon Workshop | Anycubic Photon Workshop |
| OrcaSlicer | No | — |
| Noise | ||
| Noise | — | — |
| Power | 120 W 🏆 | 180 W |
Verdict
- On price, Anycubic Photon Mono M7 Pro is cheaper.
Frequently asked
- Which has better value: Anycubic Photon Mono M7 Pro or Anycubic Photon Mono M7 Max?
- See the full spec table for the best decision based on your use case.
- Which has the larger build volume?
- Anycubic Photon Mono M7 Max with 298×164×300 mm.