Anycubic Photon P1 vs Elegoo Jupiter SE
The Anycubic Photon P1 (2026, €549) and the Elegoo Jupiter SE (2023, €629) are two MSLA 3D printers many people compare before buying.
The Anycubic Photon P1 is the more affordable of the two, with a gap of about 80 (~13%) versus the other.
On the technical side, only the Anycubic Photon P1 is enclosed (better for ABS and technical materials), and the Elegoo Jupiter SE offers more build volume (278×156×300 mm).
Below is the full spec table with the best value of each feature highlighted, plus a verdict by use case.
← Swipe to see more →
| Anycubic Photon P1 €549 | Elegoo Jupiter SE €629 | |
|---|---|---|
| Geometry | ||
| Build volume | 223×126×230 mm | 278×156×300 mm 🏆 |
| Weight | — | 19.5 kg |
| Speed | ||
| Max speed | — | — |
| Max acceleration | — | — |
| Hot-end | ||
| Max nozzle temp | — | — |
| Nozzle material | — | — |
| Drive type | — | — |
| Flow rate | — | — |
| Bed | ||
| Max bed temp | — | — |
| Bed material | — | — |
| Auto-leveling | Intelligent Leveling System 3.0 (pressure sensor assisted) | 4-point manual |
| Enclosed | Yes 🏆 | No |
| Heated chamber | No | No |
| Multimaterial | ||
| AMS compatible | No | No |
| AMS type | — | — |
| AMS slots | — | — |
| Connectivity | ||
| WiFi | Yes | No |
| Ethernet | — | — |
| Camera | Yes () | Yes () |
| Calibration | ||
| Vibration compensation | — | — |
| Flow calibration | — | — |
| Input shaping | — | — |
| Pressure advance | — | — |
| Software | ||
| Official slicer | Photon Workshop 4.0 | Chitubox |
| OrcaSlicer | — | — |
| Noise | ||
| Noise | — | — |
| Power | — | 180 W 🏆 |
Verdict
- On price, Anycubic Photon P1 is cheaper.
Frequently asked
- Which has better value: Anycubic Photon P1 or Elegoo Jupiter SE?
- See the full spec table for the best decision based on your use case.
- Which has the larger build volume?
- Elegoo Jupiter SE with 278×156×300 mm.