Anycubic Photon Mono M5s Pro vs Anycubic Photon P1
The Anycubic Photon Mono M5s Pro (2024, €499) and the Anycubic Photon P1 (2026, €549) are two MSLA 3D printers many people compare before buying.
The Anycubic Photon Mono M5s Pro is the more affordable of the two, with a gap of about 50 (~9%) versus the other.
On the technical side, the Anycubic Photon P1 offers more build volume (223×126×230 mm).
Below is the full spec table with the best value of each feature highlighted, plus a verdict by use case.
← Swipe to see more →
| Anycubic Photon Mono M5s Pro €499 | Anycubic Photon P1 €549 | |
|---|---|---|
| Geometry | ||
| Build volume | 224×126×200 mm 🏆 | 223×126×230 mm |
| Weight | 9.4 kg | — |
| Speed | ||
| Max speed | — | — |
| Max acceleration | — | — |
| Hot-end | ||
| Max nozzle temp | — | — |
| Nozzle material | — | — |
| Drive type | — | — |
| Flow rate | — | — |
| Bed | ||
| Max bed temp | — | — |
| Bed material | — | — |
| Auto-leveling | automatic | Intelligent Leveling System 3.0 (pressure sensor assisted) |
| Enclosed | Yes | Yes |
| Heated chamber | No | No |
| Multimaterial | ||
| AMS compatible | No | No |
| AMS type | — | — |
| AMS slots | — | — |
| Connectivity | ||
| WiFi | Yes | Yes |
| Ethernet | No | — |
| Camera | Yes (1080p) | Yes () |
| Calibration | ||
| Measures its own vibrations (built-in sensor) | No | — |
| Calibrates flow by itself (sensor) | No | — |
| Input shaping | No | — |
| Pressure advance | No | — |
| Software | ||
| Official slicer | Photon Workshop | Photon Workshop 4.0 |
| OrcaSlicer | No | — |
| Noise | ||
| Noise | — | — |
| Power | 120 W 🏆 | — |
Verdict
- On price, Anycubic Photon Mono M5s Pro is cheaper.
Frequently asked
- Which has better value: Anycubic Photon Mono M5s Pro or Anycubic Photon P1?
- See the full spec table for the best decision based on your use case.
- Which has the larger build volume?
- Anycubic Photon Mono M5s Pro with 224×126×200 mm.