Anycubic Kobra X vs Sovol SV07 Plus
The Anycubic Kobra X (2026, €389) and the Sovol SV07 Plus (2023, €499) are two FDM 3D printers many people compare before buying.
The Anycubic Kobra X is the more affordable of the two, with a gap of about 110 (~22%) versus the other.
On the technical side, only the Anycubic Kobra X supports multicolor (AMS), and the Sovol SV07 Plus offers more build volume (300×300×350 mm).
Below is the full spec table with the best value of each feature highlighted, plus a verdict by use case.
← Swipe to see more →
| Anycubic Kobra X €389 | Sovol SV07 Plus €499 | |
|---|---|---|
| Geometry | ||
| Build volume | 260³ mm | 300×300×350 mm 🏆 |
| Weight | 9.5 kg | 13 kg |
| Speed | ||
| Max speed | 600 mm/s 🏆 | 500 mm/s |
| Max acceleration | 20,000 mm/s² 🏆 | 12,000 mm/s² |
| Hot-end | ||
| Max nozzle temp | 300 °C | 300 °C |
| Nozzle material | Hardened steel | — |
| Drive type | direct | direct |
| Flow rate | — | — |
| Bed | ||
| Max bed temp | 100 °C | 100 °C |
| Bed material | PEI | PEI plate |
| Auto-leveling | LeviQ 3.0 (49-point mesh) | auto mesh |
| Enclosed | No | No |
| Heated chamber | No | No |
| Multimaterial | ||
| AMS compatible | Yes 🏆 | No |
| AMS type | ACE Pro | — |
| AMS slots | 4 🏆 | — |
| Connectivity | ||
| WiFi | Yes | Yes |
| Ethernet | — | — |
| Camera | Yes () | — |
| Calibration | ||
| Measures its own vibrations (built-in sensor) | Yes | — |
| Calibrates flow by itself (sensor) | — | — |
| Input shaping | Yes | Yes |
| Pressure advance | Yes | Yes |
| Software | ||
| Official slicer | Anycubic Slicer Next | OrcaSlicer (Sovol fork) |
| OrcaSlicer | — | Yes |
| Noise | ||
| Noise | 45 dB 🏆 | — |
| Power | 1450 W | 600 W 🏆 |
Verdict
- If speed matters most, the Anycubic Kobra X wins (600 mm/s vs 500 mm/s).
- On price, Anycubic Kobra X is cheaper.
Frequently asked
- Which has better value: Anycubic Kobra X or Sovol SV07 Plus?
- See the full spec table for the best decision based on your use case.
- Which has the larger build volume?
- Sovol SV07 Plus with 300×300×350 mm.