Anycubic Kobra 2 vs Anycubic Kobra X
The Anycubic Kobra 2 (2023, €279) and the Anycubic Kobra X (2026, €389) are two FDM 3D printers many people compare before buying.
The Anycubic Kobra 2 is the more affordable of the two, with a gap of about 110 (~28%) versus the other.
On the technical side, only the Anycubic Kobra X supports multicolor (AMS), and the Anycubic Kobra X offers more build volume (260³ mm).
Below is the full spec table with the best value of each feature highlighted, plus a verdict by use case.
← Swipe to see more →
| Anycubic Kobra 2 €279 | Anycubic Kobra X €389 | |
|---|---|---|
| Geometry | ||
| Build volume | 250×220×220 mm | 260³ mm 🏆 |
| Weight | 8.4 kg | 9.5 kg |
| Speed | ||
| Max speed | 300 mm/s | 600 mm/s 🏆 |
| Max acceleration | 5,000 mm/s² | 20,000 mm/s² 🏆 |
| Hot-end | ||
| Max nozzle temp | 260 °C | 300 °C 🏆 |
| Nozzle material | brass | Hardened steel |
| Drive type | direct | direct |
| Flow rate | — | — |
| Bed | ||
| Max bed temp | 110 °C 🏆 | 100 °C |
| Bed material | PEI plate | PEI |
| Auto-leveling | LeviQ 2.0 auto mesh | LeviQ 3.0 (49-point mesh) |
| Enclosed | No | No |
| Heated chamber | No | No |
| Multimaterial | ||
| AMS compatible | No | Yes 🏆 |
| AMS type | — | ACE Pro |
| AMS slots | — | 4 🏆 |
| Connectivity | ||
| WiFi | Yes | Yes |
| Ethernet | No | — |
| Camera | — | Yes () |
| Calibration | ||
| Measures its own vibrations (built-in sensor) | — | Yes |
| Calibrates flow by itself (sensor) | — | — |
| Input shaping | — | Yes |
| Pressure advance | — | Yes |
| Software | ||
| Official slicer | Anycubic Slicer Next | Anycubic Slicer Next |
| OrcaSlicer | Yes | — |
| Noise | ||
| Noise | — | 45 dB 🏆 |
| Power | 350 W 🏆 | 1450 W |
Verdict
- If speed matters most, the Anycubic Kobra X wins.
- On price, Anycubic Kobra 2 is cheaper.
Frequently asked
- Which has better value: Anycubic Kobra 2 or Anycubic Kobra X?
- See the full spec table for the best decision based on your use case.
- Which has the larger build volume?
- Anycubic Kobra X with 260³ mm.