Anycubic
Kobra X
The Anycubic Kobra X is a FDM 3D printer released in 2026 by Anycubic, with a build volume of 260³ mm and MSRP of €389. Compatible with multi-material system ACE Pro (4 slots). Maximum speed 600 mm/s. Current status: active.
€389 Manufacturer's MSRP
Manufacturer's suggested retail price (MSRP). Not the Amazon price — the actual price in stores may vary.
Technical specifications
| Technology | FDM |
|---|---|
| Build volume | 260³ mm |
| Weight | 9.5 kg |
| Max speed | 600 mm/s |
| Max acceleration | 20,000 mm/s² |
| Max nozzle temp | 300 °C |
| Nozzle material | Hardened steel |
| Drive | direct |
| Flow rate | — |
| Max bed temp | 110 °C |
| Bed material | PEI |
| Auto-leveling | LeviQ 3.0 (49-point mesh) |
| Enclosed | No |
| Heated chamber | No |
| AMS compatible | Yes (ACE Pro, 4 slots) |
| WiFi | Yes |
| Camera included | Yes () |
| Official slicer | Anycubic Slicer Next |
| OrcaSlicer support | — |
| Power | 1450 W |
| Noise | 45 dB |
What materials can it print?
Compatibility derived from its verified specs. See the full materials guide →
| Material | Prints it? | Why |
|---|---|---|
| PLA | Yes | Yes. PLA has no special needs: any FDM printer like the Kobra X prints it out of the box. |
| PETG | Yes | Yes. With a nozzle up to 300 °C and a bed up to 110 °C it comfortably meets PETG's needs. |
| TPU (flexible) | Yes | Yes. It has a direct-drive extruder, ideal for flexibles; prints TPU well (go slow). |
| ABS | With caveats | With caveats. It reaches 300 °C, but it's open-frame: ABS can warp and ventilation is advised. Doable in a draft-free spot or by adding an enclosure. |
| ASA | With caveats | With caveats. It reaches 300 °C, but it's open-frame: ASA can warp and ventilation is advised. Doable in a draft-free spot or by adding an enclosure. |
| Nylon (PA) | With caveats | With caveats. It reaches 300 °C but is open-frame; Nylon warps in drafts and absorbs moisture. Enclosure + drying almost mandatory. For carbon-fibre variants, use a hardened-steel nozzle. |
| Policarbonato (PC) | With caveats | With caveats. It has the temperature (300 °C) but is open-frame; PC warps badly without an enclosure. Only with one added. For carbon-fibre variants, use a hardened-steel nozzle. |
Popular comparisons
Sources & references
Specs cross-checked against these public sources:
- Anycubic Official Store - Kobra Xmanufacturer
- Anycubic EU Official Store - Kobra Xmanufacturer