Material compatibility
What materials the Artillery Sidewinder X4 PRO S1 can print
This comes from four facts on its spec sheet: the nozzle reaches 300 °C, the bed an unconfirmed temperature, and the machine is open-frame with an unconfirmed extruder. Those four facts decide most of the list: nozzle temperature sets the ceiling on what you can melt, the bed decides whether the first layer sticks, the enclosure keeps large parts from warping, and the extruder type rules flexibles. We don't test the machine — this is guidance derived from verified data, not a guarantee.
In short: it prints PLA without a fight, and it can reach ABS, ASA, Nylon (PA), Policarbonato (PC) with conditions — the detail for each is below.
- PLAYes
Yes. PLA has no special needs: any FDM printer like the Sidewinder X4 PRO S1 prints it out of the box.
- PETGNo data
Not verified. We're missing this model's confirmed max nozzle/bed temperature to give a verdict.
- TPU (flexible)No data
Extruder type not verified. TPU works much better with a direct drive; check before buying.
- ABSWith caveats
With caveats. It reaches 300 °C, but it's open-frame: ABS can warp and ventilation is advised. Doable in a draft-free spot or by adding an enclosure.
- ASAWith caveats
With caveats. It reaches 300 °C, but it's open-frame: ASA can warp and ventilation is advised. Doable in a draft-free spot or by adding an enclosure.
- Nylon (PA)With caveats
With caveats. It reaches 300 °C but is open-frame; Nylon warps in drafts and absorbs moisture. Enclosure + drying almost mandatory. For carbon-fibre variants, use a hardened-steel nozzle.
- Policarbonato (PC)With caveats
With caveats. It has the temperature (300 °C) but is open-frame; PC warps badly without an enclosure. Only with one added. For carbon-fibre variants, use a hardened-steel nozzle.
| Material | Prints it? | Why |
|---|---|---|
| PLA | Yes | Yes. PLA has no special needs: any FDM printer like the Sidewinder X4 PRO S1 prints it out of the box. |
| PETG | No data | Not verified. We're missing this model's confirmed max nozzle/bed temperature to give a verdict. |
| TPU (flexible) | No data | Extruder type not verified. TPU works much better with a direct drive; check before buying. |
| ABS | With caveats | With caveats. It reaches 300 °C, but it's open-frame: ABS can warp and ventilation is advised. Doable in a draft-free spot or by adding an enclosure. |
| ASA | With caveats | With caveats. It reaches 300 °C, but it's open-frame: ASA can warp and ventilation is advised. Doable in a draft-free spot or by adding an enclosure. |
| Nylon (PA) | With caveats | With caveats. It reaches 300 °C but is open-frame; Nylon warps in drafts and absorbs moisture. Enclosure + drying almost mandatory. For carbon-fibre variants, use a hardened-steel nozzle. |
| Policarbonato (PC) | With caveats | With caveats. It has the temperature (300 °C) but is open-frame; PC warps badly without an enclosure. Only with one added. For carbon-fibre variants, use a hardened-steel nozzle. |
Need the materials it struggles with? These printers handle them
Policarbonato (PC)
Sources & references
Specs cross-checked against these public sources:
- Web del fabricanteManufacturer page