hotend
ES
ES

Material compatibility

What materials the QIDI Tech X-Smart 3 can print

This comes from four facts on its spec sheet: the nozzle reaches 300 °C, the bed 120 °C, and the machine is enclosed with a direct-drive extruder. Those four facts decide most of the list: nozzle temperature sets the ceiling on what you can melt, the bed decides whether the first layer sticks, the enclosure keeps large parts from warping, and the extruder type rules flexibles. We don't test the machine — this is guidance derived from verified data, not a guarantee.

In short: it prints PLA, PETG, TPU (flexible), ABS, ASA, Nylon (PA), Policarbonato (PC) without a fight.

  • PLAYes

    Yes. PLA has no special needs: any FDM printer like the X-Smart 3 prints it out of the box.

  • PETGYes

    Yes. With a nozzle up to 300 °C and a bed up to 120 °C it comfortably meets PETG's needs.

  • TPU (flexible)Yes

    Yes. It has a direct-drive extruder, ideal for flexibles; prints TPU well (go slow).

  • ABSYes

    Yes. Nozzle up to 300 °C and an enclosure: it contains ABS's warping and fumes.

  • ASAYes

    Yes. Nozzle up to 300 °C and an enclosure: it contains ASA's warping and fumes.

  • Nylon (PA)Yes

    Yes. It reaches 300 °C and is enclosed: it prints Nylon (dry it well first). For carbon-fibre variants, use a hardened-steel nozzle.

  • Policarbonato (PC)Yes

    Yes. Nozzle up to 300 °C and an enclosure: suitable for PC. For carbon-fibre variants, use a hardened-steel nozzle.

See the full X-Smart 3 spec page → All printers table

Sources & references

Specs cross-checked against these public sources: