QIDI Tech Q2 vs Sovol SV07 Plus
The QIDI Tech Q2 (2025, €499) and the Sovol SV07 Plus (2023, €499) are two FDM 3D printers many people compare before buying.
On the technical side, only the QIDI Tech Q2 is enclosed (better for ABS and technical materials), and only the QIDI Tech Q2 supports multicolor (AMS).
Below is the full spec table with the best value of each feature highlighted, plus a verdict by use case.
← Swipe to see more →
| QIDI Tech Q2 €499 | Sovol SV07 Plus €499 | |
|---|---|---|
| Geometry | ||
| Build volume | 270×270×256 mm | 300×300×350 mm 🏆 |
| Weight | 18.1 kg | 13 kg |
| Speed | ||
| Max speed | 600 mm/s 🏆 | 500 mm/s |
| Max acceleration | 20,000 mm/s² 🏆 | 12,000 mm/s² |
| Hot-end | ||
| Max nozzle temp | 370 °C 🏆 | 300 °C |
| Nozzle material | Bimetal hardened steel | hardened steel |
| Drive type | direct | direct |
| Flow rate | — | 32 mm³/s 🏆 |
| Bed | ||
| Max bed temp | 120 °C 🏆 | 100 °C |
| Bed material | Dual-sided textured PEI | PEI plate |
| Auto-leveling | Automatic (load cell sensor integrated into hotend) | auto mesh |
| Enclosed | Yes 🏆 | No |
| Heated chamber | Yes 🏆 | No |
| Multimaterial | ||
| AMS compatible | Yes 🏆 | No |
| AMS type | — | — |
| AMS slots | 4 🏆 | — |
| Connectivity | ||
| WiFi | Yes | Yes |
| Ethernet | — | Yes |
| Camera | Yes () | — |
| Calibration | ||
| Vibration compensation | — | Yes |
| Flow calibration | — | No |
| Input shaping | — | Yes |
| Pressure advance | — | Yes |
| Software | ||
| Official slicer | QIDI Studio | OrcaSlicer (Sovol fork) |
| OrcaSlicer | — | Yes |
| Noise | ||
| Noise | — | — |
| Power | 350 W 🏆 | 600 W |
Verdict
- If speed matters most, the QIDI Tech Q2 wins (600 mm/s vs 500 mm/s).
Frequently asked
- Which has better value: QIDI Tech Q2 or Sovol SV07 Plus?
- See the full spec table for the best decision based on your use case.
- Which has the larger build volume?
- Sovol SV07 Plus with 300×300×350 mm.