Flashforge Creator 5 Pro vs Snapmaker U1
👁 This comparison has been viewed 1 times · 0 this month · 0 this week
The Flashforge Creator 5 Pro (2025, €929) and the Snapmaker U1 (2026, €899) are two FDM 3D printers many people compare before buying.
On the technical side, the Snapmaker U1 offers more build volume (270³ mm).
Below is the full spec table with the best value of each feature highlighted, plus a verdict by use case.
← Swipe to see more →
| Flashforge Creator 5 Pro €929 | Snapmaker U1 €899 | |
|---|---|---|
| Geometry | ||
| Build volume | 256³ mm | 270³ mm 🏆 |
| Weight | 18 kg | 18.2 kg |
| Speed | ||
| Max speed | 300 mm/s | 500 mm/s 🏆 |
| Max acceleration | 30,000 mm/s² 🏆 | 20,000 mm/s² |
| Hot-end | ||
| Max nozzle temp | 320 °C 🏆 | 300 °C |
| Nozzle material | hardened steel | stainless steel |
| Drive type | direct | direct |
| Flow rate | — | — |
| Bed | ||
| Max bed temp | 120 °C 🏆 | 100 °C |
| Bed material | PEI | PEI steel sheet |
| Auto-leveling | automatic | mesh |
| Enclosed | Yes | Yes |
| Heated chamber | Yes 🏆 | No |
| Multimaterial | ||
| AMS compatible | Yes | Yes |
| AMS type | toolchanger | toolchanger |
| AMS slots | 4 | 4 |
| Connectivity | ||
| WiFi | Yes | Yes |
| Ethernet | — | — |
| Camera | Yes () | Yes () |
| Calibration | ||
| Vibration compensation | — | — |
| Flow calibration | — | — |
| Input shaping | — | — |
| Pressure advance | — | — |
| Software | ||
| Official slicer | Orca-Flashforge / OrcaSlicer | Snapmaker Orca |
| OrcaSlicer | — | — |
| Noise | ||
| Noise | 55 dB 🏆 | — |
| Power | 1200 W | 1150 W 🏆 |
Verdict
- If speed matters most, the Snapmaker U1 wins.
- On price, Snapmaker U1 is cheaper.
Frequently asked
- Which has better value: Flashforge Creator 5 Pro or Snapmaker U1?
- See the full spec table for the best decision based on your use case.
- Which has the larger build volume?
- Snapmaker U1 with 270³ mm.