Anycubic Photon Mono 4 vs Elegoo Mars 4
The Anycubic Photon Mono 4 (2024, €212) and the Elegoo Mars 4 (2023, €249) are two MSLA 3D printers many people compare before buying.
The Anycubic Photon Mono 4 is the more affordable of the two, with a gap of about 37.25999999999999 (~15%) versus the other.
On the technical side, the Anycubic Photon Mono 4 offers more build volume (153×87×165 mm).
Below is the full spec table with the best value of each feature highlighted, plus a verdict by use case.
← Swipe to see more →
| Anycubic Photon Mono 4 €212 | Elegoo Mars 4 €249 | |
|---|---|---|
| Geometry | ||
| Build volume | 153×87×165 mm | 153×78×175 mm |
| Weight | 4 kg | 5.2 kg |
| Speed | ||
| Max speed | — | — |
| Max acceleration | — | — |
| Hot-end | ||
| Max nozzle temp | — | — |
| Nozzle material | — | — |
| Drive type | — | — |
| Flow rate | — | — |
| Bed | ||
| Max bed temp | — | — |
| Bed material | — | — |
| Auto-leveling | Manual 4-point | — |
| Enclosed | No | No |
| Heated chamber | No | No |
| Multimaterial | ||
| AMS compatible | No | No |
| AMS type | — | — |
| AMS slots | — | — |
| Connectivity | ||
| WiFi | No | No |
| Ethernet | — | — |
| Camera | — | — |
| Calibration | ||
| Vibration compensation | — | — |
| Flow calibration | — | — |
| Input shaping | — | — |
| Pressure advance | — | — |
| Software | ||
| Official slicer | Photon Workshop | Voxeldance Tango |
| OrcaSlicer | — | — |
| Noise | ||
| Noise | — | — |
| Power | 54 W 🏆 | — |
Verdict
- On price, Anycubic Photon Mono 4 is cheaper.
Frequently asked
- Which has better value: Anycubic Photon Mono 4 or Elegoo Mars 4?
- See the full spec table for the best decision based on your use case.
- Which has the larger build volume?
- Elegoo Mars 4 with 153×78×175 mm.