Anycubic Kobra 2 vs Creality Ender 3 V3 KE
👁 This comparison has been viewed 1 times · 0 this month · 0 this week
The Anycubic Kobra 2 (2023, €279) and the Creality Ender 3 V3 KE (2023, €279) are two FDM 3D printers many people compare before buying.
On the technical side, the Anycubic Kobra 2 offers more build volume (250×220×220 mm).
Below is the full spec table with the best value of each feature highlighted, plus a verdict by use case.
← Swipe to see more →
| Anycubic Kobra 2 €279 | Creality Ender 3 V3 KE €279 | |
|---|---|---|
| Geometry | ||
| Build volume | 250×220×220 mm 🏆 | 220×220×240 mm |
| Weight | 8.4 kg | 7.8 kg |
| Speed | ||
| Max speed | 300 mm/s | 500 mm/s 🏆 |
| Max acceleration | 5,000 mm/s² | 8,000 mm/s² 🏆 |
| Hot-end | ||
| Max nozzle temp | 260 °C | 300 °C 🏆 |
| Nozzle material | brass | copper alloy |
| Drive type | direct | direct |
| Flow rate | — | 32 mm³/s 🏆 |
| Bed | ||
| Max bed temp | 110 °C 🏆 | 100 °C |
| Bed material | PEI plate | PEI plate |
| Auto-leveling | LeviQ 2.0 auto mesh | CR Touch + strain gauge |
| Enclosed | No | No |
| Heated chamber | No | No |
| Multimaterial | ||
| AMS compatible | No | No |
| AMS type | — | — |
| AMS slots | — | — |
| Connectivity | ||
| WiFi | Yes | Yes |
| Ethernet | No | Yes |
| Camera | — | — |
| Calibration | ||
| Vibration compensation | Yes | Yes |
| Flow calibration | No | Yes |
| Input shaping | Yes | Yes |
| Pressure advance | Yes | Yes |
| Software | ||
| Official slicer | Anycubic Slicer Next | Creality Print |
| OrcaSlicer | Yes | Yes |
| Noise | ||
| Noise | — | — |
| Power | 350 W | 350 W |
Verdict
- If speed matters most, the Creality Ender 3 V3 KE wins.
Frequently asked
- Which has better value: Anycubic Kobra 2 or Creality Ender 3 V3 KE?
- See the full spec table for the best decision based on your use case.
- Which has the larger build volume?
- Anycubic Kobra 2 with 250×220×220 mm.