Anycubic Kobra 3 vs Bambu Lab A1 Mini
The Anycubic Kobra 3 (2024, €369) and the Bambu Lab A1 Mini (2023, €299) are two FDM 3D printers many people compare before buying.
The Bambu Lab A1 Mini is the more affordable of the two, with a gap of about 70 (~19%) versus the other.
On the technical side, the Anycubic Kobra 3 offers more build volume (250×250×260 mm).
Below is the full spec table with the best value of each feature highlighted, plus a verdict by use case.
← Swipe to see more →
| Anycubic Kobra 3 €369 | Bambu Lab A1 Mini €299 | |
|---|---|---|
| Geometry | ||
| Build volume | 250×250×260 mm 🏆 | 180³ mm |
| Weight | 9.6 kg | 5.5 kg |
| Speed | ||
| Max speed | 600 mm/s 🏆 | 500 mm/s |
| Max acceleration | 20,000 mm/s² 🏆 | 10,000 mm/s² |
| Hot-end | ||
| Max nozzle temp | 300 °C | 300 °C |
| Nozzle material | brass | stainless steel |
| Drive type | direct | direct |
| Flow rate | 32 mm³/s 🏆 | 28 mm³/s |
| Bed | ||
| Max bed temp | 110 °C 🏆 | 80 °C |
| Bed material | PEI plate | PEI plate |
| Auto-leveling | LeviQ 3.0 25-point | load cell + auto mesh |
| Enclosed | No | No |
| Heated chamber | No | No |
| Multimaterial | ||
| AMS compatible | Yes | Yes |
| AMS type | ACE Pro | lite |
| AMS slots | 4 | 4 |
| Connectivity | ||
| WiFi | Yes | Yes |
| Ethernet | No | No |
| Camera | Yes (720p) | Yes (1080p) |
| Calibration | ||
| Measures its own vibrations (built-in sensor) | Yes | Yes |
| Calibrates flow by itself (sensor) | Yes | Yes |
| Input shaping | Yes | Yes |
| Pressure advance | Yes | Yes |
| Software | ||
| Official slicer | Anycubic Slicer Next | Bambu Studio |
| OrcaSlicer | Yes | Yes |
| Noise | ||
| Noise | — | 48 dB 🏆 |
| Power | 400 W | 150 W 🏆 |
Verdict
- If speed matters most, the Anycubic Kobra 3 wins (600 mm/s vs 500 mm/s).
- On price, Bambu Lab A1 Mini is cheaper.
Frequently asked
- Which has better value: Anycubic Kobra 3 or Bambu Lab A1 Mini?
- See the full spec table for the best decision based on your use case.
- Which has the larger build volume?
- Anycubic Kobra 3 with 250×250×260 mm.